Tips teach you how to tell if a diamond is working well.

Many merchants will call their diamond ring work first-class. If it is the first time to buy a diamond ring, it is difficult to distinguish the quality in a short time. Today, Xiaobian teaches you how to judge the pros and cons of diamond ring work, so that everyone can buy more peace of mind.

    Is the diamond inlaid firmly?

    There are a lot of mosaic methods, as described in the previous article, such as the embedding method, two-prong setting, etc. For this type of diamond, not only need to safely grasp the diamond, but also make the diamond pavilion There are no gaps in the contact with the metal below.

    Whether the shape meets the designer's requirements

    How to design the diamond ring is symmetrical, its pattern and shape can not be off-center, or two-sided symmetry, or four-sided symmetry, can never appear symmetrical two sides of unevenness or size inconsistency.

    The metal surface looks cracked and the inner surface is smooth

    Improper casting, welding, and quality alloys leave these traces. The fine workmanship of the diamond ring will not leave a rough surface, and there will be no uneven edges. Good quality diamond ring, fine processing, smooth surface, fine quality, no knife cuts, no burrs; the pattern of the ring is harmonious, fine and clear, and the pattern is smooth.



    Weld seams or marks on the diamond ring

    Good quality diamond ring, fine processing, smooth surface, fine quality, no knife cuts, no burrs; the pattern of the ring is harmonious, fine and clear, and the pattern is smooth. The circle is well-proportioned, and the width and width are moderate; if it is gold-plated or gold-plated ring, its surface should be bright and uniform, the color is consistent, and there is no phenomenon of stomata, black spots or dullness at the corner and bump junction; the welding point should be smooth and there is no virtual welding phenomenon.

    Diamond ring ring with the ring to see if the two are right or not

    Generally, a good work diamond ring, the ring face is slightly heavier than the ring foot, if it is not very good work. In case of overweight, the diamond ring will fall to the fingertips of the finger. The method of inspection is to put the ring on the little finger first, keep it loose, and gently shake it, so that the ring face does not turn to the lower end of the flat finger.

    See here that I believe that everyone knows more or less how to identify the diamond ring work is good or bad!! About the tips to teach you how to distinguish the work of diamonds is good to come here, where the road jewelry showcase is looking forward to working with you.