The design specification of the jewelry display cabinet of the exhibition cabinet is introduced.

Specification of design specification for jewelry store display case of shenzhen display factory:

Wall jewelry store display cabinet such as cosmetics display case, shenzhen display cabinet production.

1. The height of the wall container is 2400mm(back plate 2400mm), and the width is 300~500mm;Jewelry store shelves, shenzhen cases to make layout design should be considered in does not affect the fire control facilities, air conditioning, all kinds of access port, door and public channel use requirements, such as high cabinets, shelves, shenzhen under production from vents, warm wind mouth not less than 500 mm.

2. The display cabinet of the jewelry store, the height of the partition plate of the production room of the shenzhen display cabinet: 1200mm between the edge of the aisle and the front line of the counter, the height of 1350mm, and then the partition to the wall of 2400mm high;If the partition between the two cabinets is a column and the cylinder is located at the edge of the channel, the partition height of the cylinder to the wall is 2400mm;If the partition between the two cabinets is a column and the cylinder is not located on the edge of the channel, the partition height of the cylinder to the wall is 2400mm, and the partition height of the cylinder to the channel is 1350mm.

3, if the jewelry store shelves, shenzhen requirements of making the cases and lintel, just hang at the bottom of the lintel above the ground is 2400 mm, lintel its height is 300 mm, must be made of acrylic hollow out word technique, and must pay attention to the jewelry store shelves, shenzhen exhibition shelves to make cohesion between the lintel.Special hangers are determined according to the brand's image requirements and field conditions.

2. The exhibition cabinet of zhongdao jewelry store, the production of shenzhen display cabinet.

1. The display cabinet of the jewelry store, the height of the production interval of the display cabinet in shenzhen, and one half of the depth of the back counter of the extension counter, is the partition of 1350mm high.

2. The display cabinet of jewelry store in the main aisle of the garment area, the production of shenzhen display cabinet and the exhibition counter of reverse jewelry store, the partition height between the production of shenzhen display cabinet is 2400mm;In addition, the display cabinets of the jewelry stores are separated from the production line of the shenzhen display cabinet by 600mm to a height of 1350mm.

3. The shelf height is 1350mm (except special shelf).Back off

4. The height of the flat cabinet is 900mm and the width is 600mm.

5, if the jewelry display ark lintel, hanging at the bottom of the lintel is apart from the ground in 2400 mm, lintel its height is 300 mm, must be made of acrylic hollow out word technique, and must pay attention to the jewelry store shelves, shenzhen cases to make cohesion between the lintel.

Third, special jewelry store display case, shenzhen display cabinet production.

1. The display case of the jewelry store at the cashier's desk, the production of the shenzhen display cabinet is designed and made with the actual situation.

2. The atrium will be displayed in the jewelry store on both sides of the escalator. The production of the display cabinet in shenzhen shall be made through a half-side cabinet with a height of 1350mm.

3. If the jewelry store display case, the shenzhen display cabinet will make the columns on the channel line, and the side of the column must be made with a height of 2400mm.

This article is provided by shenzhen Funroad jewelry display cabinet direct selling manufacturer: 20 years of jewelry store display cabinet design experience, 2018 will help you to rapidly improve the brand value.