How to Solve the Leakage of Display Cabinet and the Reasons of Leakage

Show cabinets and some other commercial display cabinets have been used for a long time, more or less, there will be some leakage phenomenon, so it is certainly not feasible to go on, whether it is on display cabinets, or exhibits will have an impact, so we should regularly check the maintenance of display cabinets in daily maintenance.

First, the wires are worn out and there is no insulating layer: if the wires are damaged by long-term wet environment or by long-term friction of certain objects, the insulating layer will be damaged, then the wires will have to be replaced at this time.

Second: Compressor unit leakage: three sockets used in the display cabinet, when using hands to operate, keep hands not wet before switching on and off the electrified display cabinet, regular inspection and replacement of compressors.

Third: poor interface contact: loose contact control, copper wire connected with the shell, or wrong wiring, the copper wire connected with the ground wire, which will cause the display cabinet leakage phenomenon, which can be eliminated after one overhaul.

Above is the basic reason for the leakage of display cabinet. Usually, we should pay more attention to the details and check regularly. If we can't solve the problem, we should contact the operator or the display cabinet manufacturer.

This is the introduction of how to solve the leakage of display cabinet and the causes of leakage. Funroad Commercial Show looks forward to cooperating with you.